27 28
29 30
Setting the Master flash
SETTING THE REMOTE FLASH
Group A
Group B
Group C
Master Flash
CREATIVE FLASH LIGHTING:
Set Master flash.
Set Slave flash/ flashes.
Make sure the channel and its group setting are correct.
Attach the Master flash to the camera and place the Slave flash/ flashes at any
desirable place within the system operation area, which is approximately 7 to
10 meters between the Master and Slave flash/ flashes depending on the
setting condition.
A variety of custom settings enable you to customize your Di866.
TTL exposure level is accurately calibrated for standard
balance in accordance with Nissin’s standard. If any
adjustment is however required, or if you like to set your
own preferable level, it can be adjusted for about ±3ev. by
every 1/3 steps.
From 6 icons, select Custom setting mode and set .
Select the item to be customized and set the
value to customize.
7 custom settings are prepared.
Custom settings
Set
TTL Exposure level custom setting
A short pulse of flash light released by the test button
illuminates the subjects and monitors the lighting efficiency
on the subject.
Modeling
Illuminating the subject to find its lighting
efficiency.
Rotate
Cancel the rotating action and keep the image fixed.
The screen won’t rotate.
ft/meter
For the user who prefers distance indication by feet.
Select ft instead of meter.
To save battery energy, or imply to avoid the display illumination, the display
screen can be switched off when not in operation. Set it off, and the display
goes off in 8 seconds after the last operation. The display will not be woken
up by the camera’s shutter release. The display can only be woken up by any
operation button of Di866.
Display
Display can be set off if it’s not necessary.
My TTL
Those customized value and conditions are effective on all modes(*) and
memorized even the flash unit is switched off.
To reset the customized value or conditions, select Reset, choose
“Yes” and set . All the memorized data is cancelled and Di866 is reset
to the default value and condition.
Set
Auto Off
Auto off timing can be selected from 10min. 15min. 30min.
45min. 60min. or off (cancel).
Reset
All those customs setting is reset to the
default value and conditions which are
provided and set at the factory.
In the main page
Select Wireless mode.
In the Wireless page
Select Master mode.
In the Master page
Netvigate the cursor and adjust the value according to the
instruction at the bottom bar.
Cursor Netvigation
Value Adjust
Channel Select
Select Channel: Ch1, Ch2, Ch3 & Ch4
Zoom Select
Select Zoom Mode: Auto, 24mm, 28mm, 35mm, 50mm,
70mm, 85mm, 105mm
Group Setting
Group
M = Master Flash
A = Group A
B = Group B
C = Group C
Flash Mode
TTL = TTL Mode
M = Manual Mode
--- = Flash off
Value Adjustment
Ev compensation at TTL mode
(-0.3Ev to +3.0Ev)
Power Ratio at M mode
(1/1, 1/2, 1/4, 1/8, 1/16,
1/32, 1/64, 1/128)
The modes available on the Master flash are TTL and M mode.
The master flash sets the signal transmission channel, flash reflector zooming
position, flash mode of the master flash itself and flash mode and value
adjustment of the Remote flash at A, B and C respectively.
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels